Charles Mingus - AddictionToThePresent

If a new development from labs at MIT pans out as expected, someday the entire surface area of a building’s
windows could be used to generate electricity —without interfering with the ability to see through them.

The key technology is a photovoltaic cell based on organic molecules, which harnesses the energy of infrared light
while allowing visible light to pass through. Coated onto a pane of standard window glass, it could provide power
for lights and other devices, and would lower installation costs by taking advantage of existing window structures.

Richard Lunt, one of the researchers who developed the new transparent solar cell,
demonstrates its transparency using a prototype cell.

Photo: Geoffrey Supran

These days, anywhere from half to two-thirds of the cost of a traditional, thin-film solar-power system comes from those installation costs, and up to half of the
cost of the panels themselves is for the glass and structural parts, said Vladimir Buloviæ, professor of electrical engineering in the Department of Electrical Engineering and Computer Science. But the transparent photovoltaic system he developed with Richard Lunt, a postdoctoral researcher in the Research Laboratory of Electronics, could eliminate many of those associated costs, they say.

A paper by Buloviæ and Lunt describing their new system has been published online in the journal Applied Physics Letters, and will appear in a forthcoming issue
of the print edition.

Previous attempts to create transparent solar cells have either had extremely low efficiency (less than 1 percent of incoming solar radiation is converted to electricity), or have blocked too much light to be practical for use in windows. But the MIT researchers were able to find a specific chemical formulation for their cells that, when combined with partially infrared-reflective coatings, gives both high visible-light transparency and much better efficiency than earlier versions — comparable to that of non-transparent organic photovoltaic cells.

In a new building, or one where windows are being replaced anyway, adding the transparent solar cell material to the glass would be a relatively small incremental
cost, since the cost of the glass, frames and installation would all be the same with or without the solar component, the researchers say, although it is too early in the process to be able to estimate actual costs. And with modern double-pane windows, the photovoltaic material could be coated on one of the inner surfaces, where it would be completely protected from weather or window washing. Only wiring connections to the window and a voltage controller would be needed to complete the system in a home.

In addition, much of the cost of existing solar panels comes from the glass substrate that the cells are placed on, and from the handling of that glass in the factory. Again, much of that cost would not apply if the process were made part of an existing window-manufacturing operation. Overall, Buloviæ says, “a large fraction
of the cost could be eliminated” compared to today’s solar installations.

This will not be the ultimate solution to all the nation’s energy needs, Buloviæ says, but rather it is part of “a family of solutions” for producing power without greenhouse-gas emissions. “It’s attractive, because it can be added to things already being deployed,” rather than requiring land and infrastructure for a whole
new system.

Fine-tuning the cells

The work is still at a very early stage, Buloviæ cautions. So far, they have achieved an efficiency of 1.7 percent in the prototype solar cells, but they expect that with further development they should be able to reach 12 percent, making it comparable to existing commercial solar panels. “It will be a challenge to get there,” Lunt
says, “but it’s a question of excitonic engineering,” requiring optimization of the composition and configuration of the photovoltaic materials.

The researchers expect that after further development in the lab followed by work on manufacturability, the technology could become a practical commercial product within a decade. In addition to being suitable for coating directly on glass in the manufacture of new windows, the material might also be coated onto flexible material that could then be rolled onto existing windows, Lunt says.

Using the window surfaces of existing buildings could provide much more surface area for solar power than traditional solar panels, Buloviæ says. In mornings and evenings, with the sun low in the sky, the sides of big-city buildings are brightly illuminated, he says, and that vertical “footprint” of potential light-harvesting area
could produce a significant amount of power.

A prototype of the MIT researchers' transparent solar cell is seen on top of a promotional item for MIT's 150th anniversary celebrations.

Photo: Geoffrey Supran

Max Shtein, associate professor of materials science and engineering at the University of Michigan, says, “This work demonstrates a useful effect, and is based
on very sound science and engineering.” But he adds that “it is but one of the many other methods by which a similar functionality could be achieved,” and says the biggest uncertainty at this point is that because they are so new, “the lifetime of organic PV cells is a bit of an unknown at this point, though there is some hope.”

In addition, Shtein says, “The potential of this technology is good if projected far into the future,” but only if the efficiency can be improved as the researchers
expect it can.

As added benefits, the manufacturing process for the MIT researchers' solar cells could be more environmentally friendly, because it does not require the energy-intensive processes used to create silicon solar cells. The MIT process of fabricating solar cells keeps the glass panes at ordinary room temperature, Buloviæ noted. Installations of the new system would also block much of the heating effect of sunlight streaming through the windows, potentially cutting down on air conditioning needs within a building.

The research was funded by the Center for Excitonics, an Energy Frontier Research Center funded by the U.S. Department of Energy.

Contacts and sources:

David L. Chandler, MIT News Office

AddictionToThePresent

Hate on a plate

Truth hurts Lies kill -.Real truth behind the phony warCOMING SOONREDRESSING A GRIPE

Gaming Addiction: An Overview of Signs, Symptoms and Causes

High Risk Factors for Gaming Dependency

Accessibility of Gaming

Poor Role Models

Dual Diagnosis Issues

Low Sense of Self-Worth

Financial Hardship

Craving for Social Interactions

At-Risk Demographics for Gaming Addiction

Chemical Imbalances in the Brain and Body

Psychological and Emotional Issues

Sunday, May 1, 2011

Sunday, May 1, 2011

MIT Turns Windows Into Transparent Power Plants

1 comments:

Google Translate

iRAP, Inc

Search This Blog

Reports

Press Releases and Announcements Welcome

Permission to Reprint

Blog Archive

CUSTOM ANALYSIS

My Blog List

Nanotechnology News

Carbon Nanotubes

Nanocatalyst

Thin Films & Nanotechnology

Patents and Intellectual Property

Biofuels

Solar Energy

Nanowerk Nanotechnology Portal

Nanocomposite

Fuel Cell

Nanoparticle

Nano Patents and Intellectual Property

Animal Rescue

Nanomaterials

Nano Patents and Innovations

Quantum Dots

MEMS

Nanofabrication and Nano Manufacturing

About Me

Quantum Dots

Biological Nanotechnology

Nanocoatings

Microfluidics

Nanowire

Nanotechnology Links

Truth hurts Lies kill -.Real truth behind the phony war

COMING SOON
REDRESSING A GRIPE